PDMOVIE Remote Air Pro 3 Single Channel Wireless Follow Focus System

Mobile App

Remote Air App

The controller and Receiver motor have a built-in Bluetooth module. An iPhone IOS APP controls the lens, and lens data, and sets automated lens movements.

Handwheel Controller

Handwheel

The controller features a 75mm diameter large follow handwheel, which is more effective when using the palm of your hand to pull focus. or when wearing gloves. With four 1/4" screw treads, it can be easily attached to the included handle or mounted on virtually any handle, motor, or arm.

Focus, Iris, Zoom

The handwheel incorporates a focus controller, and a zoom rocker, allowing you to simultaneously control up to three axes with the proper number of motors. The focus controller features a built-in LED light and glow-in-dark marking disks that allow you to see your custom markings in low-light situations

Battery Life

The controller uses a replaceable 600mAh battery, supports a hot plug, and features a battery life of 12 hours.

Data Display

The controller and receiver motor both use the same data display mode and the LED screens are placed so that the data can be easily read.

All-in-One Control Button

The Remote Air Pro 3 features an all-in-one multifunction button. It allows you to quickly set the signal channel, control channel, motor speed, and remote recording.

Remote Run/Stop

The handwheel controller is compatible with RED and ARRI as well as LANC control of your camera's run/stop.

Handwheel Handle

The Remote Air Pro 3 includes a redesigned handle from previous versions. You can now mount and unmount the handwheel from the handle. The handle incorporates nine 1/4"-20 mounting holes that allow you to mount accessories such as a mobile device, monitor, wireless receiver, and lanyard. The handle is made of high-strength aluminium alloy and durable rubber.

Wired or Wireless

If you want to operate the focus controller in wired mode, simply connect the 6-pin motor drive cable from the motor to the controller.

Motor

Motor Improvements

• The Remote Air motor is 1.70 cm thick, down from the previous generation's 1.9 cm
• It also has twice the amount of torque of the previous motor
• The motor also has 8192 DPI (steps of resolution), which is significantly higher than the previous version's 1920 DPI, this provides the motor with increased accuracy
• The receiver motor's OLED screen has been moved to the side for easier viewing. It can display the signal channel, signal strength, and the controller's battery information

Motor Power

The new MOTOR AIR supports 7 to 20V input voltage, which means that it can now be used with a 7.2V power supply.

Calibration

You can calibrate your lens manually or automatically, adjust the lens speed from slow to medium or fast, change the motor direction, cancel the calibration, and recover the calibration.