Rode VideoMic Pro Rycote (1-RODVMPR)

SKU
119862
product overview
product overview
  • Broadcast Quality Condenser Microphone

  • Rycote Lyre Shockmount

  • 40 Hz to 20 kHz Frequency Response

  • Lightweight

  • Lower Noise and Higher Sensitivity

  • 9V Battery Powered (not included)

  • 1/8" Mini-Jack Output

  • Two-Step High Pass Filter

  • Three-Position Level Control

  • Includes Camera Shoe Mount

$219.00
In stock
BONUS
Rode DeadCat Artificial Fur Wind Shield Rycote

Free shipping on orders over $99

The RØDE VideoMic Pro R is a true shotgun microphone designed for use with camcorders, DSLR cameras and portable audio recorders as a source of primary and reference audio.

At the heart of the VideoMic Pro R is an all-new 1/2" condenser capsule that provides broadcast-quality audio via a 3.5mm minijack connector (outputting the mono signal to both left and right channels) with an incredibly low self-noise of just 14db. A super-cardioid polar pattern ensures that surrounding audio is minimised, and your recording is focused on the subject in front of the camera.

The integrated Rycote® Lyre® based shock mounting system separates the VideoMic Pro R capsule and electronics from its mount, providing isolation from external physical factors that may cause unwanted rumble and vibrations in the microphone. Constructed from a single piece of hard-wearing thermoplastic, the Lyre® provides superior acoustic suspension to traditional elastic solutions, and will never wear out, sag or snap.

Easily accessible on the rear face of the microphone are the power, filter and level controls. In addition to the microphone's native 40Hz-20kHz response a selectable high-pass filter at 80Hz is available, which will prevent low end noise such as air conditioners and traffic from being recorded.

Below these controls are the level settings, which attenuate or boost the recorded level as required. The -10dB level attenuation (or PAD) is ideal for recording loud sound sources, such as live music, motorsport, or interviews where the subject is very close to the camera. The +20dB level boost is designed for use with DSLR cameras, allowing the user to reduce the camera's preamp level (or mic-input level), effectively reducing the amount of noise generated by the camera's comparatively low quality audio circuitry.

The microphone uses a standard sized shoe mount for on camera use, and features a 3/8" thread in the base of the mount for easy boom pole mounting.

The VideoMic Pro R is battery powered, and provides over 70 hours recording from a single 9V battery.

The RØDE VideoMic is designed and made in Australia, and covered by RØDE Microphones' industry leading 10 year warranty.

  • MPN - VMPR
  • GTIN - 698813004195
+ Read more
NameValue
BrandRode
Level MetersThree-position (-10 dB, 0, +20 dB)
Frequency Response40 Hz - 20 kHz (selectable HPF @80 Hz)
Low Frequency Roll-Off80 Hz High Pass Filter
Maximum Output+6.9 dBu (@ 1% THD into 1 kOhms)
Dynamic Range120 dB (as per IEC 651)
Output Impedance200 Ohms
Polar PatternSupercardioid
Dimensions75 x 100 x 170 mm
Weight85g
Acoustic PrincipleLine Gradient Condenser
Signal to Noise Ratio80 dB
Equivalent Noise14 dB
Maximum SPL134 dB (@ 1 kHz, 1% THD into 1 kOhms load)
Output Connection1 x 1/8" (3.5 mm) stereo mini-jack (dual mono)
Sensitivity-32 dB re 1 V/Pa (20 mV @ 94 dB SPL) 2 dB @ 1 kHz
Batteries1 x 9 V alkaline battery (current 7.8 mA)
+ Read more
Write Your Own Review
You're reviewing:Rode VideoMic Pro Rycote (1-RODVMPR)
Your Rating
+ Read more
What’s In The Box

Rode VideoMic Pro Rycote (1-RODVMPR)

Read Our Helpful Buying Guides

Helpful Buying Guide