Benro MoveOver8B Carbon Fiber Slider with Case

product overview
product overview
  • Includes SuperUser Group Membership
  • 0.6m of Slider Carriage Travel
  • Carriage Features 3/8"-16 Mounting Stud
  • Smooth, Quiet Ball Bearing Slides
  • Friction-Adjusting Knob and Brake
  • 18mm Carbon Fiber Rails
  • Supports over 7.7 kg
  • Multi-Adjustable All-Terrain Legs
  • Micro-Adjust Non-Scratch Feet
  • 0 to 90° and Underslung Operation
In stock
Express Shipping now available

This Benro MoveOver8B Carbon Fiber Slider with Case includes an aluminum slider carriage that runs on carbon fiber rails with 59.9 cm of actual carriage travel, and a soft carry case. The carriage features a flat mounting surface with a 3/8"-16 threaded mounting stud for mounting your flat base fluid head, and it features pre-tensioned roller bearings for a smooth glide. A built-in friction brake is controlled by a single knob, allowing you to adjust the friction on the slider, or even use it as a brake when the slider is level.

The slider features 18mm diameter carbon fiber rails and supports a total payload of up to 17.6 pounds. The slider can be mounted on a tripod or stands, or placed on a level surface. The built-in bubble level enables you to confirm that your slider is level. Each leg mounts onto the slider track ends via a rosette and can rotate throughout 360°, and each foot has approximately 10.16 cm of height adjustment for leveling. You can operate the slider on any angle from 0 to 90°, and you can even undersling the slider.

  • The adjustable legs can be moved throughout 360° of rotation. However, they are at their most supportive between 12 and 60°.
  • The track ends allow you to mount the slider on stands using the Baby pin slot. Each track end features 1/4"-20 and 3/8"-16 threaded mounting holes.
  • The slider can also be mounted directly onto a tripod using the 3/8"-16 or 1/4"-20 threaded mounting hole on the attached cheese plate.
  • The carriage has four 1/4"-20 threaded mounting holes for accessories.
  • MPN - C08D6B
  • GTIN - N/A
+ Read more
Load Capacity Horizontal:32 kg (23 kg with extensions)
Vertical:11 kg (with camera up to 24.8 cm out from carriage)
Upside-Down:20 kg
Load Capacity 7.71 kg
Bubble level Yes
Actual Slider Carriage Travel 0.6 m
Body Material Aluminum
Carriage Dimensions 166.0 x 119.0 x 13.0 mm
Quick Release Plate Type No Quick Release
Rail Material Carbon Fiber
Rail Diameter 18 mm
Stand Receiver 5/8" x 2 
Tripod Mounting 3/8"-16 Female Thread x 2
1/4"-20 Female Thread
Accessory Mounting 1/4"-20 Female Thread (Carriage)  x 4
1/4"-20 Female Thread (Rails) x 3
3/8"-16 Female Thread (Rails)
1/4"-20 and 3/8"16 accessory mounting threads x 2
1/4"-20 on the underside
Camera Mounting Screw 3/8"-16 Male
Track Width 100 mm
+ Read more
Write Your Own Review
You're reviewing:Benro MoveOver8B Carbon Fiber Slider with Case
Your Rating
+ Read more
What’s In The Box
  • Benro MoveOver8B Carbon Fiber Slider with Case

Read Our Helpful Buying Guides

Helpful Buying Guide
+ Read more
What’s In The Box
  • Benro MoveOver8B Carbon Fiber Slider with Case

Read Our Helpful Buying Guides

Helpful Buying Guide