Free shipping on orders over $99
This Benro MoveOver8B Carbon Fiber Slider with Case includes an aluminum slider carriage that runs on carbon fiber rails with 23.6" of actual carriage travel, and a soft carry case. The carriage features a flat mounting surface with a 3/8"-16 threaded mounting stud for mounting your flat base fluid head, and it features pre-tensioned roller bearings for a smooth glide. A built-in friction brake is controlled by a single knob, allowing you to adjust the friction on the slider, or even use it as a brake when the slider is level.
The slider features 18mm diameter carbon fiber rails and supports a total payload of up to 17.6 pounds. The slider can be mounted on a tripod or stands, or placed on a level surface. The built-in bubble level enables you to confirm that your slider is level. Each leg mounts onto the slider track ends via a rosette and can rotate throughout 360°, and each foot has approximately 4" of height adjustment for leveling. You can operate the slider on any angle from 0 to 90°, and you can even undersling the slider.
- The adjustable legs can be moved throughout 360° of rotation. However, they are at their most supportive between 12 and 60°.
- The track ends allow you to mount the slider on stands using the Baby pin slot. Each track end features 1/4"-20 and 3/8"-16 threaded mounting holes.
- The slider can also be mounted directly onto a tripod using the 3/8"-16 or 1/4"-20 threaded mounting hole on the attached cheese plate.
- The carriage has four 1/4"-20 threaded mounting holes for accessories.
- MPN - C08D6B
- GTIN - N/A
|Load Capacity||Horizontal: 70 lb / 32 kg (50 lb / 23 kg with extensions) Vertical: 24.2 lb / 11 kg (with camera up to 9.8" out from carriage) Upside-Down: 50 lb / 20 kg|
|Load Capacity||7.71 kg|
|Actual Slider Carriage Travel||0.6 m|
|Carriage Dimensions||166.0 x 119.0 x 13.0 mm|
|Quick Release Plate Type||No Quick Release|
|Rail Material||Carbon Fiber|
|Rail Diameter||18 mm|
|Stand Receiver||2 x 5/8"|
|Tripod Mounting||2 x 3/8"-16 Female Thread |
1 x 1/4"-20 Female Thread
|Accessory Mounting||4 x 1/4"-20 Female Thread (Carriage) |
3 x 1/4"-20 Female Thread (Rails)
1 x 3/8"-16 Female Thread (Rails)
Two 1/4"-20 and one 3/8"16 accessory mounting threads on the top of each of the track ends, one 1/4"-20 on the underside
|Camera Mounting Screw||3/8"-16 Male|
|Track Width||100 mm|